GSO ASTM F406:2022
Gulf Standard
Current Edition
·
Approved on
12 May 2022
·
Standard Consumer Safety Specification for Non-Full-Size Baby Cribs/Play Yards
GSO ASTM F406:2022 Files
No files are available for this standard right now!
You can buy this standard from any member store
GSO ASTM F406:2022 Scope
1.1 This consumer safety specification establishes testing
requirements for structural integrity and performance requirements for non-full-size cribs/play yards, both rigid sided and
mesh/fabric assemblies. It also provides requirements for
labeling and instructional material. The term unit or product
will refer to a non-full-size crib/play yard.
1.2 This specification covers a framed enclosure with a floor
made for the purpose of providing sleeping and playing
accommodations for a child who cannot climb out and is less
than 35 in. (890 mm) in height. It also covers bassinet,
changing table, or similar accessories to a non-full size
crib/play yard. These accessories shall also comply with the
applicable requirements of ASTM standards addressing those
accessories. For example, a changing table that attaches to a
play yard shall also comply with the applicable requirements in
Specification F2388. This specification does not cover inflatable products.
1.3 No product produced after the approval date of this
consumer safety specification shall, either by label or other
means, indicate compliance with this specification unless it
conforms to all applicable requirements contained herein,
before and after all testing.
1.4 The values stated in inch-pound units are to be regarded
as standard. The values given in parentheses are mathematical
conversions to SI units that are provided for information only
and are not considered standard.
1.5 The following safety hazards caveat pertains only to the
test method portion, Section 8, of this specification: This
standard does not purport to address all of the safety concerns,
if any, associated with its use. It is the responsibility of the user
of this standard to establish appropriate safety, health, and
environmental practices and determine the applicability of
regulatory limitations prior to use.
Best Sellers From Mechanical Sector
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
GSO 98:1988
Gulf Technical Regulation
MOTOR VEHICLES- FLAMMABILITY OF
INTERIOR MATERIALS AND THEIR
TESTING METHODS
GSO 1780:2010
Gulf Technical Regulation
Motor vehicle-vehicle identification number (vin) - requirements
Recently Published from Mechanical Sector
GSO ASTM D4778:2024
ASTM D4778:15
Gulf Standard
Standard Test Method for Determination of Corrosion and Fouling Tendency of Cooling Water Under Heat Transfer Conditions (Withdrawn 2024)
GSO ISO 22407:2024
ISO 22407:2021
Gulf Standard
Metallic materials — Fatigue testing — Axial plane bending method
GSO ISO 24513:2024
ISO 24513:2019
Gulf Standard
Service activities relating to drinking water supply, wastewater and stormwater systems — Vocabulary
GSO EN 14622:2024
EN 14622:2005
Gulf Standard
Devices to prevent pollution by backflow of potable water - Air gap with circular overflow (restricted) - Family A, type F